How to Fix a Hole in Drywall, Drywall, or Concrete
Since different walls are made of different materials, the methods you use to repair a hole will often be specific and adapted to the wall that needs to be repaired. Here’s how you can fix your more standard wall problems so you can patch up rips, craters, and dents.
Drywall or plaster
“Any home built in the last 50 years will have drywall,” said Lifehacker Timothy Dahl, editorial director of Charles and Hudson ‘s adventure and home improvement website. Drywall is a composite material that is used in the construction of interior walls and ceilings, and chances are it is used in your home as well.
Fixing a Drywall Hole is the easiest household funnel you can encounter. To fix a hole in drywall, you will need some supplies, such as a drywall knife, plaster or putty, a sanding block, or sandpaper to cover the bases. You can start by cutting out any jagged or amorphous edge of the hole to create a uniform shape.
Dahl recommends purchasing a drywall screen that you can wedge into a crack and begin to cover with putty or sealant. You will need to fill the hole with whatever binder you are using, let it dry, and then sand it down. As Real Homes points out , the sanding part is critical to getting the job done. The website recommends sanding again “until the renovation is smooth and the edges are completely flush with the wall.”
Dahl points out another workaround, noting that “you can also buy smaller pieces of drywall and cut them to size, then smooth the edges with dirt / seam sealant.”
It is worth noting that this is relatively the same with drywall, as many consider it indistinguishable from drywall. However, there are others who advise a different approach, which you might want to familiarize yourself with if you deem it necessary.
How to repair a hole in concrete
Now about the heavy duty materials. A hole in the concrete is more likely to appear in the outer wall, which is good because it is a dirtier job than repairing drywall. To get started, you will need a mask, gloves, and safety goggles. Other materials required to get the job done are provided by SF Gate below :
- Screwdriver
- Putty knife
- Metal brush
- Wet / dry vacuum cleaner
- Spray bottle filled with water
- Hydraulic cement
- Clean mixing container
- Trowel (optional)
What follows is a simple process, but it is still a little more complicated than the typical garden renovation you may be used to. First, you need to remove any excess debris or jagged edges from the hole with a knife, clean it off with a wire brush, and then vacuum the excess before dampening the hole with water.
SF Gate outlines the next steps in the process, which, believe it or not, take a minimum of 24 hours to complete due to the need for drying.
Mix a small amount of hydraulic cement in a clean container according to package directions. Stir the cement with a spatula to a thick peanut butter consistency. Make as much cement as you can use in three minutes or less.
Pour hydraulic cement firmly into the hole with a trowel or trowel. Smooth the surface of the patch as quickly as possible before the cement sets.
Spray the patch lightly with water several times over the next 24 hours. Let the patch cure for 48 hours before painting, or for as long as recommended by the manufacturer.
Repairing something like a brick can be a more difficult and challenging process, as Dahl warns that “you don’t want to damage your mortar” by doing something wrong. Of course, there are many options at your disposal if you want to strike at yourself.